ESA hands over control of the Metop-B weather satellite to EUMETSAT
Yesterday, at 18:30 local time EUMETSAT took control of Metop-B operations, following the three-day Launch and Early Orbit Phase (LEOP) conducted by the European Space Operations Centre (ESOC) of the European Space Agency (ESA). The handover follows the launch of Metop-B on 17 September.
Since Monday evening, teams at ESA’s European Space Operations Centre in Darmstadt, Germany, have been busy day and night during the Launch and Early Orbit Phase. As planned, they checked all of Metop-B’s systems and ensured that its solar array was deployed and oriented towards the Sun to provide crucial power to run the satellite and its 11 scientific instruments.
On Day One, the ESA Flight Operations teams checked the power, temperatures, software, telecommunication links and activated a number of systems. On Day Two, they deployed five payload instrument antennas. On Day Three, with Metop-B in a near-circular orbit at around 800 km altitude and 99 degrees inclination, the teams conducted one thruster burn to fine tune the orbit and get into ‘phase’ with the orbit of Metop-A - and to prepare for handover to EUMETSAT on Thursday.
After the handover, work began immediately on the in-orbit verification of Metop-B, for a six-week period, during which all Metop-B’s 11 instruments will be switched on in sequence.
Global Satellite Transponder Market
The European instruments on board Metop-B will be activated in the following order:
- GOME-2 ultraviolet spectrometer for ozone monitoring five days after launch
- ASCAT advanced scatterometer one week after launch
- GRAS instrument for atmospheric sounding using radio-occultation of signals from the Global Navigation Satellite System (GNSS) one week after launch
- MHS microwave humidity sounder (three and a half weeks after launch
- IASI infrared atmospheric sounder six weeks after launch
Altogether, these instruments will deliver measurements of vertical profile of temperature, humidity and trace gases in the atmosphere, the wind field at the surface of the ocean, and soil moisture.
The Metop-B in-orbit check out activities will use the comprehensive EUMETSAT Polar System (EPS) ground segment. They will be coordinated by the EUMETSAT Control Centre located at EUMETSAT’s headquarters in Darmstadt, Germany, with the support of ESA, the French space agency CNES, NOAA (National Oceanic and Atmospheric Administration) and industry.
Source : European Space Agency (ESA)