US FAA Grants 330-Minute ETOPS Approval to GEnx-1B PIP Engine
The U.S. Federal Aviation Administration (FAA) has granted 330-minute extended-range, twin-engine operations (ETOPS) Approval to 14 CFR Part 33.201 for the GEnx-1B Performance Improvement Program (PIP) engine, which will power the Boeing 787 Dreamliner aircraft. This follows the 330-minute ETOPS approval that was granted to the GEnx-1B baseline engine late last year.
The FAA approval confirms the engine has demonstrated the required reliability to conduct ETOPS operations up to 330 minutes flying time from a primary or alternate airport. ETOPS approval provides airlines much greater route-scheduling flexibility as it allows twin-engine aircraft to service routes traditionally reserved for three- and four-engine aircraft.
Solid Oxide Fuel Cell Global Market Outlook - Trends, Forecast, and Opportunity Assessment (2014-202...
Boeing recently completed all flight tests of the GEnx-powered Boeing 787 Dreamliner aircraft expected to be required for FAA type certification. The engine performed extremely well in flight-testing. The GEnx-1B baseline and PIP engine have already received FAA engine certification.
Based on proven GE90 architecture, the GEnx engine succeeds GE's CF6 engine. Compared to the CF6 engine, the GEnx will offer up to 15 percent improved fuel efficiency, which translates to 15 percent less CO2. The GEnx's innovative twin-annular pre-swirl (TAPS) combustor will dramatically reduce NOx gases as much as 55 percent below today's regulatory limits and other regulated gases as much as 90 percent. Based on the ratio of decibels to pounds of thrust, the GEnx will be the quietest engine GE has produced due to the large, more efficient fan blades that operate at slower tip speed, resulting in about 30 percent lower noise levels. The GEnx will be the world's only jet engine with both a front fan case and fan blades made of carbon fiber composites.
Revenue-sharing participants on the GEnx are IHI Corporation of Japan, Avio SpA. of Italy, Volvo Aero of Sweden, MTU of Germany, TechSpace Aero of Belgium, Snecma (SAFRAN Group) of France and Samsung Techwin of Korea.
The GEnx is part of GE's "ecomagination" product portfolio - GE's business strategy to develop new, cost-effective technologies that enhance customers' environmental and operating performance.
Source : GE Aviation
Oct 11 - 12, 2016 - Washington, United States